JOHN LEWIS JTDC01
Manual de Usuario

Setting time delay

3 With of a DELAY START button, you can delay (30' the the start programme by between 30 minutes
and a maximum of 23 hours (23h). 1.Select the programme 2.Press the DELAY START button as many times as necessary until the required start delay appears on the multi display, e.g. 12h if the programme is to be started in 12 hours. The DELAY START display is illuminated.

Drying cycle complete / removing laundry
Once the drying cycle is complete, the END and CREASE GUARD indicators light up. If the ALARM button has been pressed, an acoustic signal sounds intermittently.

3 The drying cycles (except for the WOOL prolaundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming.) If ANTI-CREASE has been selected, the anti-crease phase is lengthened by 60 minutes. 1.Open door. 2.Before removing the laundry, remove fluff from the microfine filter. It is best to use a damp hand for this purpose. (See �Cleaning and maintenance� section.) 3.Remove laundry. 4.Turn the programme selector to OFF. Important: After each drying cycle � Clean the micro-fine filter and fine filter � Drain the condensed water container (See section �Cleaning and maintenance�.) 5.Close door. gramme) are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the

the time delay will be cancelled. The display will show 0' and then the duration of the selected programme. 3.To activate the delay timer, press the START/PAUSE button. The amount of time remaining until the programme is set to start is continuously displayed (e.g. 12h, 11h, 10h, � 30' etc).

3 If 23h is displayed and you press the button again,

3 Until the start of the programme the drum is moved
at longish intervals to loosen the laundry.

Starting the programme
Press the START/PAUSE button. The programme is started. The programme progress display and the display showing the level of dryness show drying progress.

Changing programme
To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF and then reset the programme.

3 The programme can nohas started.changed directly longer be once the programme If nevertheless

there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the ALARM button) is pressed, Err appears in the multidisplay. The drying programme is not however affected by this (laundry protection).

Removing laundry or loading laundry when necessary
1.Open loading door

1 Warning! Laundry and drum can become hot. Risk of burns!
2.Load or remove laundry items. 3.Close the door securely. Lock must audibly lock. 4.Press the START/PAUSE button to continue the drying cycle.

14